Basic NOT Gate

A NOT gate, often called an inverter, is one of the most fundamental building blocks in Minecraft redstone. It takes an incoming redstone signal and flips it to the opposite state—turning an ON signal OFF, and an OFF signal ON. You will use this tiny component constantly when building hidden piston doors, traps, and automated farms where a mechanism needs to stay powered by default.

Logic GatesBeginnerJava Edition
Basic NOT Gate video tutorial

Video: How to build a NOT Gate in Minecraft - 1 Minute Redstone Tutorial by The Academy of Geekery

How to build it

  1. Clear a 1x1x2 Space

    Find a 1-block wide, 2-block long, and 1-block high space along your redstone line where you want to invert the signal.

  2. Place the Solid Block

    Place one solid building block of your choice on the ground in the first space of your 1x2 area.

  3. Attach the Redstone Torch

    Place a redstone torch on the front side of the solid block so it faces away from your incoming power source.

  4. Connect the Input and Output Lines

    Run your incoming redstone dust line directly into the back of the solid block, and place your outgoing redstone dust line directly in front of the redstone torch.

How it works

The basic NOT gate relies on the native mechanics of a Redstone Torch attached to an opaque block:

  • When Input is OFF: The solid block is unpowered. Because a redstone torch is naturally active by default, it stays lit and sends a full strength power signal (level 15) into the output redstone line.
  • When Input is ON: The incoming redstone dust powers the solid block. When the block a redstone torch is attached to becomes powered, the torch is forced to turn off ( after a 1 redstone tick delay), cutting all power to the output line.

Tips & variations

  • Watch the Space Above: As mentioned in the video, avoid running unrelated redstone lines directly above the redstone torch, because a lit torch strongly powers the block directly on top of it and will interfere with circuits above.
  • Block Choice Matters: You must use a solid, opaque block (such as stone, cobblestone, or wool). Transparent blocks like glass or slabs cannot be powered to turn off a torch, and you cannot attach torches to the sides of most transparent blocks.
  • Directing the Input: Make sure your incoming redstone dust points directly into the solid block (or run a redstone repeater into the block) so the block actually receives the power.

Frequently asked questions

Why isn't my redstone torch turning off when the input is on?
Make sure the incoming redstone dust is pointing directly into the solid block. If the dust runs past the side of the block without pointing into it, the block won't be powered and the torch will stay on.
How much space does a basic NOT gate take?
The gate itself only requires a 1-block wide, 1-block high, and 2-block long (1x1x2) area, plus the input and output redstone lines.
Can I put redstone on top of the NOT gate?
You should avoid running separate circuits right above the redstone torch, because the torch powers the block space directly above it and will interfere with any redstone sitting there.

Components used

More not gate