
Video: 1-Wide Tileable Precision Autocrafter (1.21+) by Brandon Henness
How to build it
- Lay the Base Blocks
Start your 1-wide slice by placing two solid building blocks, three glass blocks, and one more solid block in the layout for the comparator and dust lines. Using glass prevents redstone lines from cutting each other off while keeping the slice 1-wide.
- Place the Redstone Dust and Comparators
Place two redstone dust on the glass/block line, then position two redstone comparators reading along the circuit path. Add the third comparator at the upper level where it will read the reference signal.
- Install the Observer
Place an observer so its face is looking directly at the redstone dust line. It will detect signal changes in the dust and pass a pulse forward.
- Add the Reference Crafter and Copper Bulb
Place a crafter (used purely as a signal strength reference) and a copper bulb next to the observer/comparator logic. Open the reference crafter and disable 7 of the 9 slots so it outputs a signal strength of 7.
- Set the Active Crafter and Hopper
Place the main crafting crafter at the front of the slice and attach a hopper feeding items into it. Make sure the copper bulb is toggled to its OFF state before starting.
- Configure Your Recipe
Open the main crafter and disable any unused slots for your chosen recipe (for example, leave 2 slots open for pressure plates, 6 for iron bars, or all 9 for blocks). Drop your raw materials into the hopper to begin automatic crafting.
How it works
This circuit relies on comparator signal strength and a copper bulb to prevent double-pulsing:
- The upper reference crafter has 7 of its 9 slots toggled closed, producing a constant signal strength of
7through its comparator. - As the hopper feeds items into the main crafter, its comparator output increases by 1 for every filled or disabled slot.
- Once all 9 slots in the main crafter are either disabled or contain at least one item, the comparator output reaches full strength and triggers the redstone dust line.
- The observer and copper bulb work together as a T flip-flop/pulse filter so that the crafter receives only a single crafting pulse per full recipe cycle, rather than double-firing when the signal drops back down.
Tips & variations
- 2+ Slot Recipes Only: This design works for any recipe that uses between 2 and 9 crafting slots (shears, pressure plates, bars, full blocks). It does not work for 1-slot recipes like ingots to nuggets; use a simple clock-based crafter for those.
- Reset the Copper Bulb: After building or toggling slots in the reference crafter, you will trigger the observer. Always check that the copper bulb is reset to its unlit state before feeding items in.
- Chunk Unloading Note: Because it uses a copper bulb state, unloading the chunk at the exact split-second it crafts could desync the bulb. If a slice stops crafting, simply toggle the copper bulb once to reset it.
- Multi-Item Recipes: You can craft multi-ingredient recipes as long as your input system inserts the items in the exact slot order required.





