How Weighted Pressure Plates Work
Weighted pressure plates activate whenever an entity's hitbox intersects the bottom quarter-block (0.25 blocks) of the plate's space. All valid entities—including players, mobs, dropped items, fired arrows, fishing bobbers, and experience orbs (excluding snowballs)—carry the exact same "weight."
Once activated, a weighted pressure plate remains powered for a minimum of 1 second. After all entities leave its detection zone, it takes 5 redstone ticks (0.5 seconds) to turn off, which is twice as fast as the 10-tick reset time of stone and wooden plates.
While active, the plate:
- Powers adjacent
redstone_dust, as well as anyredstone_repeaterorredstone_comparatorfacing away from it, to its current power level. - Strongly powers any full, solid, opaque block directly beneath it to the same signal strength.
- Activates adjacent mechanism blocks (above, below, or beside it) such as pistons, doors, redstone lamps, droppers, and TNT.
Light vs. Heavy Signal Strength Table
There are two variants of weighted pressure plates, each scaling its output from power=0 to power=15 at different rates:
- Light Weighted Pressure Plate (Gold): Increases signal strength by 1 for every single entity on the plate. It reaches maximum power (15) at 15 or more entities.
- Heavy Weighted Pressure Plate (Iron): Increases signal strength in increments of 10 entities. It outputs strength 1 for 1–10 entities, strength 2 for 11–20 entities, and so on, reaching maximum power (15) at 141 or more entities.
- Strength 1: 1 entity (Light) | 1–10 entities (Heavy)
- Strength 2: 2 entities (Light) | 11–20 entities (Heavy)
- Strength 3: 3 entities (Light) | 21–30 entities (Heavy)
- Strength 4: 4 entities (Light) | 31–40 entities (Heavy)
- Strength 5: 5 entities (Light) | 41–50 entities (Heavy)
- Strength 6: 6 entities (Light) | 51–60 entities (Heavy)
- Strength 7: 7 entities (Light) | 61–70 entities (Heavy)
- Strength 8: 8 entities (Light) | 71–80 entities (Heavy)
- Strength 9: 9 entities (Light) | 81–90 entities (Heavy)
- Strength 10: 10 entities (Light) | 91–100 entities (Heavy)
- Strength 11: 11 entities (Light) | 101–110 entities (Heavy)
- Strength 12: 12 entities (Light) | 111–120 entities (Heavy)
- Strength 13: 13 entities (Light) | 121–130 entities (Heavy)
- Strength 14: 14 entities (Light) | 131–140 entities (Heavy)
- Strength 15: 15+ entities (Light) | 141+ entities (Heavy)
Placement Rules & Support Blocks
A weighted pressure plate must be placed on top of a valid supporting surface. It cannot be attached to the sides or undersides of blocks. Valid supports include:
- Any full, solid, opaque block (including mechanism blocks like dispensers, droppers, note blocks, and redstone lamps).
- The top of a
hopper. - The top of a fence or nether brick fence.
- Upside-down slabs and upside-down stairs.
Weighted pressure plates are non-solid blocks (0.0625 blocks tall when inactive, depressing to 0.03125 blocks when active). Entities walk directly on the supporting block beneath them. Additionally, water and lava flow around pressure plates without breaking them, making them useful near liquid streams.
Common Redstone Circuits & Uses
- Mob Farm Entity Counters: Heavy weighted pressure plates are widely used in mob grinders and XP farms to prevent entity cramming. By placing mobs onto an iron plate and reading a specific signal strength threshold, you can automatically close a piston gate or activate a crusher once 20 or 30 mobs have accumulated.
- Pass-Through Fence Detectors: Because a fence has a narrower collision box than a full block, placing a weighted pressure plate on top of a fence allows players, mobs, or falling items to pass around or drop past the edges of the fence post while still intersecting the plate's detection zone. This creates a compact, 1-block tripwire alternative.
- Diagonal Rail Detectors: A minecart traveling along a diagonal rail track will clip into and activate a pressure plate placed immediately adjacent to the track, though a plate next to a straight track will not be triggered.
- Hopper Item Intake Sensor: Placing a weighted pressure plate directly on top of a hopper lets you detect when dropped items land on the hopper before they are sucked inside.
Tips & Common Mistakes
- Item Stacks Count as One Entity: A single dropped stack of 64 cobblestone and a single dropped wooden sword both count as exactly 1 entity. When multiple identical items land on a plate separately, the signal strength may spike momentarily and then drop as the items merge into a single stack entity.
- Use Unstackable Items for Precision: If you are using dropped items with a light weighted pressure plate to generate a specific signal strength, dispense unstackable items (such as tools, armor, or empty buckets) so they cannot merge on the plate.
- Always Mine with a Pickaxe: Unlike wooden pressure plates, light and heavy weighted pressure plates require a pickaxe to drop as an item. Breaking them by hand destroys the plate.
- Piston Fragility: Never push a weighted pressure plate with a piston or move its supporting block, as the plate will immediately pop off.
Version history
- Java 1.7.2Weighted pressure plates were updated to detect all entity types (previously they only detected dropped items) and their entity count thresholds were lowered to 1 per strength level for gold and 10 per level for iron.
