
Video: Minecraft: The Slimeblock Mega Jumper by Mumbo Jumbo
How to build it
- Clear a 3x2 Footprint
Find a 3x2 area for the launcher. Place your first solid building block at the bottom with a button attached to its front side.
- Build the Torch Tower Pillar
Starting from the button block, place solid blocks going upwards in an alternating checkerboard pattern to form the frame of a vertical redstone torch tower.
- Place the Redstone Torches
Fill in all the vertical gaps on both sides of your tower with redstone torches so the signal alternates and travels all the way to the top. Place one more solid block above the final torch and put a piece of redstone dust on top of it.
- Install the Upper Launcher
Next to the top piece of redstone dust, place an upward-facing sticky piston. Put a slime block directly on top of that sticky piston.
- Install the Lower Launcher
Go back down to the base of the tower. Place a redstone torch next to the input block, position an upward-facing sticky piston next to it, and top it with your second slime block.
- Add the Immovable Backstop Wall
Place an immovable block (such as obsidian or furnaces) diagonally adjacent to the lower slime block, then build it two more blocks up to create a 3-block-tall guide wall. Press the button and walk against this wall to launch 11 blocks up.
How it works
This launcher relies on the natural 1-redstone-tick delay per torch in a vertical torch tower to perfectly time two consecutive slime block bounces:
- First Launch: Pressing the
buttonpowers the bottom block, inverting the adjacentredstone torchand firing the lowersticky piston. The bottomslime blockthrows the player approximately 5 blocks upward. - Signal Delay: At the same time, the button signal climbs the vertical column of alternating
redstone torches. Each torch adds a brief delay as it toggles the one above it. - Second Boost: Just as you reach the peak of your initial bounce alongside the upper piston, the signal reaches the
redstone dustat the top of the tower. The uppersticky pistonextends itsslime block, catching your feet mid-air and boosting you an additional 6 blocks for a total jump height of 11 blocks.
Tips & variations
- Use Immovable Blocks: The 3-block guide wall that you walk against must be made of immovable blocks like obsidian, furnaces, or glazed terracotta so the moving slime blocks do not grab the wall and jam the pistons.
- How to Ride It: Stand on the lower slime block, press the button, and immediately hold forward to hug the guide wall. Staying pressed against the wall aligns your hitbox with the upper slime block edge for the second bounce.
- Inverted Pistons Notice: Depending on the exact height of your torch tower, one of the pistons may sit extended at rest until the button pulse briefly retracts and re-extends it. Add or remove one torch step if a piston stays extended by default.


