
Video: How To Make A TNT Launcher In Minecraft! - (Launch Your Friends With Ease) by Farzy
How to build it
- Build a 5x5 Frame
Place 5 solid building blocks in a row, then extend the sides to create a hollow 5x5 square outline on the ground with a 3x3 open center.
- Raise the Walls
Add a second layer of building blocks directly on top of the first ring so the entire 5x5 outer wall is 2 blocks tall.
- Place the Center Fence
Stand inside the 3x3 pit and place a single fence post on the floor in the exact middle block.
- Add the Water
Place one water bucket in each of the four inside corners on the bottom layer. The water will flow inward toward the central fence post.
- Wire the Redstone Rim
Place a button on top of the middle block of one outer wall, then cover the remaining 15 top wall blocks with redstone dust to form a complete ring.
- Load the TNT
Place 8 TNT blocks along the top inside layer, forming a ring around the central fence post just above the water source blocks.
- Stand and Launch
Hop onto the top of the central fence post, press the button to ignite the TNT, and wait to be blasted straight into the air.
How it works
This launcher relies on Minecraft's water and explosion physics to propel entities without destroying the machine:
- Signal Distribution: Pressing the button outputs a redstone signal of strength 15. Because the perimeter of the 5x5 frame is only 16 blocks around, the signal easily travels 8 blocks in both directions through the
redstone dust, powering every block of the top rim simultaneously. - TNT Ignition: Each powered redstone dust on the rim activates the adjacent
TNTblock placed inside the 3x3 opening. Once lit, the TNT becomes a falling entity and drops into the water below. - Water Containment & Push: The four corner water sources create currents pushing inward toward the center fence. This pulls the primed TNT slightly closer to the middle while completely absorbing block damage when it detonates.
- Vertical Knockback: Standing on the 1.5-block-tall fence post elevates your hitbox slightly above the center of the TNT blasts, converting the combined explosion force of all 8 TNT into pure upward velocity.
Tips & variations
- Wear Armor or Hold a Water Bucket: Even inside water, 8 TNT detonating at once deals significant explosion damage, followed by lethal fall damage on the way down. Wear Blast Protection / Feather Falling armor, use a Totem of Undying, or land with an Elytra or water bucket.
- Never Cover the Water Corners: When reloading the 8 TNT, make sure you place them on the upper inside layer next to the redstone dust, not down in the bottom corners where the water source blocks sit.
- Reloading: Because the water protects the blocks, you only need to place 8 new TNT around the top layer after each launch.
- Launching Mobs: Only tough mobs with large health pools (such as Iron Golems, Ravagers, Hoglins, or Elder Guardians) can survive the blast intact.


