
Video: Minecraft Tutorial: Fire Alarm System by sirknightj
How to build it
- Set Up the Latch Inputs
Clear a 2x3 area for the memory latch. Wire your emergency trigger lever(s) into one corner of this area, and wire your master reset button into the opposite diagonal corner.
- Build the RS NOR Latch
Place one solid building block in each of those two opposite corners. Attach a redstone torch to the inward-facing side of each block, then place redstone dust in the remaining spaces of the 2x3 footprint so each torch powers the opposite block.
- Connect the Comparator Clock
From the lever side of your 2x3 latch, extend a line of two redstone dust out from the circuit. Place a redstone comparator facing forward at the end of this dust and interact with it once to turn on its front torch (subtract mode).
- Add the Repeater Feedback Loop
Place a redstone repeater directly in front of the comparator and set it to a 3-tick delay. From the output of the repeater, run three pieces of redstone dust around to the right side so the line feeds back into the side of the comparator.
- Install the Output Torch
Attach a redstone torch to the side of the output block at the end of your clock section to pass the pulsing signal forward.
- Wire the Lights and Note Blocks
Run a redstone dust line from the output of your clock to your warning redstone lamps and note blocks. Pull the lever to test the flashing lights and audio, then flip the lever back off and press the reset button to turn the alarm off.
How it works
This circuit combines a basic memory cell with a pulse generator to behave like a real-world emergency alarm:
- RS NOR Latch (2x3 Section): The two blocks and two redstone torches form a basic memory latch. Pulling the lever turns off the first torch, which allows the second torch to turn on and lock the first torch off. Even if the lever is flipped back to the off position, the latch remains in its triggered state until the reset button sends a pulse to the opposite block to flip the states back.
- Subtraction Clock: Once the latch activates, it sends a steady signal into the back of the
redstone-comparator(set to subtract mode). The signal flows through the 3-tickredstone-repeaterand loops back into the side of the comparator, repeatedly subtracting the signal from itself to create a steady on/off pulse. - Alarm Output: The pulsing signal travels down the output wire, causing the connected redstone lamps to flash and the note blocks to chime repeatedly until the latch is reset.
Tips & variations
- Multiple Pull Stations: You can connect as many trigger levers as you want from different rooms in your building—just merge all their redstone lines into the same input corner of the 2x3 latch.
- Lever Reset Warning: Before pressing the reset button, make sure the triggered lever has been flipped back to the OFF position. If a lever is still sending a constant ON signal into the latch, pressing the reset button will only pause the alarm briefly.
- Adjusting Flash Speed: If the lights and note blocks pulse too fast or fail to toggle properly, adjust the delay on the repeater in front of the comparator.





