
Video: Automatic Jukebox | Minecraft 1.20+ [Java Edition] by mcpeachpies
How to build it
- Place the Upward Dropper
Start one block below your floor level and place a dropper facing straight up. This dropper will hold your music discs and randomize which track plays next.
- Add the Lower Hopper and Jukebox
Attach a hopper feeding into the side of the dropper. Place your jukebox directly on top of this lower hopper so it sits at floor level.
- Connect the Upper Hopper
Place a second hopper directly above the dropper, aiming into the side of the jukebox. This forms a 2x2 clockwise item loop between the dropper, hoppers, and jukebox.
- Position the Top Observer
Move to the back of the build. Place an observer behind the top hopper with its face looking at the hopper and its redstone output pointing straight back.
- Place the Solid Block and Note Block
Directly behind the top observer's output, place a solid building block. Beneath that solid block, place a note block (or any block that changes state when powered).
- Install the Bottom Observer
Underneath the top observer, place your second observer facing the note block so its output points directly into the back of the dropper.
- Attach the Control Lever and Load Discs
Place a lever on top of the jukebox or on a wall block adjacent to the top hopper. Load your music discs into the dropper, then flick the lever on and back off to start the automatic playback.
How it works
This circuit takes advantage of two jukebox mechanics added in Minecraft 1.19.4: hoppers can insert and extract music discs, and a playing jukebox emits a full-strength redstone signal of 15.
- Playing State: While a music disc is playing, the jukebox powers both adjacent hoppers. This locks the top hopper so another disc cannot enter, and locks the bottom hopper so the active disc isn't pulled out early.
- Track Change Detection: When the song ends, the jukebox stops emitting a redstone signal and unlocks both hoppers. The bottom hopper immediately pulls the finished disc out and pushes it into the dropper, while the top hopper pushes the next waiting disc into the jukebox.
- Observer Loop & Randomizer: Whenever the top hopper locks or unlocks, the top
observerdetects the state change and powers the solid block behind it. That block updates thenote-blockbelow it, which triggers the bottomobserverto fire thedropper. Because droppers choose a filled slot at random, it pushes a shuffled disc up into the top hopper to keep the queue full. - On/Off Switch: Flipping the
leveron permanently powers and locks the top hopper, allowing the current song to finish without loading another disc.
Tips & variations
- Stop Dropper Clicking: If you only load one or two discs, the dropper may occasionally click when empty slots exist. Fill the dropper and hoppers with multiple discs to keep it quiet and maximize the shuffle variety.
- Skip Song Button: You can manual-skip a track at any time by right-clicking the jukebox to pop the disc out. Run an extra input chest and hopper into the dropper so you can easily toss skipped discs back into rotation.
- Java Quasi-Connectivity Note: A playing jukebox powers the space around it, which can cause quasi-connectivity (BUD) issues with the dropper in Java Edition. Using the two-observer and note block chain works around this cleanly by sending block updates directly when songs start and stop.




