
Video: Minecraft: Item Counters [Tutorial] by EliTheWolf
How to build it
- Set Up the Hopper Stream
Place at least three hoppers in a straight line connecting your input and output chests. Place a redstone comparator reading out of the side of the middle hopper.
- Place the Counter Dropper and Hopper
Next to the comparator from the main line, place a dropper facing downstream (in the same direction as the main hopper line). Attach a hopper feeding directly back into that dropper; the dropper will hold the exact number of items you want to count.
- Read the Dropper and Return Hopper
Place two solid blocks beside the dropper and its attached hopper. On top of these blocks, place two comparators facing away from the dropper and hopper to read their contents.
- Build the Hopper Latch
In front of the two comparators you just placed, install two hoppers facing directly into each other. Cover the tops of both hoppers with two solid building blocks, then place a single item inside the right-hand hopper.
- Add the Lower Comparators
Underneath the two mutually facing hoppers, place two support blocks so you can place two more comparators reading out of the pair of hoppers.
- Wire the Reset and Output Torch
On the side of the lower comparators, place two blocks with a piece of redstone dust to carry the signal. On the opposite side, place a block with a redstone torch on top to serve as the counter output and reset lock.
- Program the Item Count
Open the dropper and insert as many stackable items as you want the circuit to count (for example, 3 items to trigger an output every 3 items that pass through the main hopper pipe).
- Optional: Convert to an Item Packet Transmitter
To release items in exact batches instead of a continuous stream, place a solid block on top of the output redstone torch with a second redstone torch on its side. Add a piece of redstone dust next to it to lock the main hopper line during reset, and place a solid block to cut off the unwanted wire connection.
How it works
This counter combines a dropper-hopper counter with a hopper RS-NOR latch so that it automatically resets itself after reaching the target number:
- Counting items: As each item flows through the middle hopper of your main stream, the comparator detects it and pulses the dropper. The dropper pushes one counting item into its attached hopper.
- Triggering the latch: while the dropper still has items, its comparator keeps the two mutually facing hoppers locked in their counting state. Once the last item leaves the dropper, its comparator turns off, allowing the single item inside the hopper pair to shift to the other side.
- Self-resetting: When the single item shifts inside the hopper latch, the lower comparator turns off the redstone torch locking the dropper's return hopper. All counted items drain back from the hopper into the dropper. Once the return hopper is completely empty, the latch flips back and the circuit is ready for the next batch.
- Packet transmission (Design 3): The extra torch and redstone dust lock the main item stream while the counter resets, creating a clean pause between batches (for example, sending packets of 5 or 10 items at a time).
Tips & variations
- Super Smelter Optimization: Use the packet transmitter variant before a furnace minecart loader and set the dropper count to a multiple of your furnace count. Every furnace will receive the exact same number of items, preventing uneven coal consumption.
- Button Press Counter: You can adapt the exact same core circuit to count manual button presses instead of a hopper stream by running a button input into the dropper.
- Common Mistake: Make sure only one item is placed inside the two hoppers facing each other. Putting multiple items in the latch hoppers will break the reset timing.



