
Video: Minecraft Tutorial The Smallest Piston Door in Minecraft 1x2 1.12 by MrBlockHead
How to build it
- Place the Sticky Pistons
Stack two sticky pistons on top of each other, facing sideways into the 1x2 space where your doorway will be.
- Attach the Door Blocks
Place two solid building blocks directly onto the sticky faces of both pistons. These blocks will push out to close your doorway.
- Position the Torch Block
Use a temporary block behind the top piston to place a solid building block one space behind and behind the upper piston, then break the temporary block.
- Insert the Redstone Torch
Place a redstone torch on the underside or side of that rear block so that it sits directly behind the pistons and powers both of them to extend.
- Add the Buttons
Place one button on each side of the block holding the redstone torch so you can trigger the door from both the front and the back.
- Build the Door Frame (Optional)
Surround the doorway with solid building blocks on the front and back to hide the pistons and create a clean hallway frame.
How it works
This circuit relies on signal inversion and compact piston powering:
- Default Closed State: The
redstone-torchis attached to a solid block next to the twosticky-pistoncomponents. By powering the space directly adjacent to the top piston and above the bottom piston, both pistons stay extended by default, keeping the door shut. - Opening the Door: Pressing either
buttonstrongly powers the block holding the redstone torch. - Signal Inversion: When the block becomes powered, the attached redstone torch turns off for the duration of the button pulse. Both sticky pistons immediately retract their door blocks, allowing you to walk through before the torch turns back on.
Tips & variations
- Easier Walkthrough Upgrade: Because the buttons are close to the redstone mechanism, walking through quickly can be tricky. To give yourself more time, remove the buttons from the torch block, place a
redstone-repeaterset to 4 ticks pointing into the torch block on each side, place a solid block behind each repeater, and attach your buttons to those new blocks. - Wooden vs. Stone Buttons: Use wooden buttons instead of stone buttons to get a longer redstone pulse, keeping the door open slightly longer without needing extra repeaters.
- Non-Flush Design: Note that this is a standard recessed 1x2 door rather than a flush piston door, meaning the door sits one block inset from the outer wall frame.
- Java vs. Bedrock Note: Depending on exact torch placement, powering two vertically stacked pistons from a single elevated power source relies on Java Edition connectivity mechanics.



