
Video: ✔️ Minecraft 1.21: Redstone Tutorial - Compact 2x2 Piston Door by MrCrayfish
How to build it
- Dig the Central Trench
Start by digging a 2x3 hole in the ground that is 2 blocks deep. Cover the entire floor of this pit with 6 pieces of redstone dust.
- Dig the Side Wings
Locate the middle row of the 3-block-long side of your hole. Dig 2 blocks outward at the full 2-block depth, then dig 1 more block outward just 1 block deep to create a step. Repeat this exact trench on the opposite side.
- Wire the Side Trenches
Place 2 redstone dust along the bottom of the 2-block-deep wing on each side so it connects to the central grid. Then, place 1 redstone torch on the raised 1-block-deep step at the very end of both wings.
- Cover the Wiring
Place a solid building block directly on top of both redstone torches. Fill in the remaining open trench with your building blocks to create a flat floor over the redstone dust.
- Position the Sticky Pistons
Place a sticky piston next to the block sitting above the left redstone torch, facing inward toward the center of the door. Stack a second sticky piston directly on top of it, and repeat this on the right side.
- Power the Top Pistons
Notice that only the bottom pistons are currently extended. Place 1 piece of redstone dust on top of the solid block above each redstone torch to power the upper sticky pistons.
- Install the Door and Pressure Plates
Place your 4 door blocks (such as glass) onto the faces of the extended sticky pistons to form the 2x2 door. Finally, put 2 pressure plates on the ground directly in front of the door on both sides.
How it works
This circuit works by using redstone torches as signal inverters (NOT gates) to keep the door closed by default:
- Default State (Closed): When no one is standing on the pressure plates, the underground
redstone-dustis unpowered. This allows the tworedstone-torchcomponents at the ends of the trenches to remain lit. - Powering the Pistons: Each lit torch strongly powers the solid block directly above it. This powered block activates the bottom
sticky-pistonadjacent to it and also powers theredstone-dustsitting on top of the block, which activates the uppersticky-piston. Both pairs of pistons stay extended, keeping the door shut. - Triggered State (Open): Stepping on any of the four
pressure-plateinputs sends a redstone signal through the floor blocks into the central 2x3 grid of dust. This power travels down both side trenches into the blocks holding the redstone torches, turning the torches off and retracting all four sticky pistons simultaneously.
Tips & variations
- Solid Blocks Required: The blocks placed directly over the redstone torches and under the pressure plates must be solid, opaque blocks (like stone, wood planks, or wool). Do not use glass or slabs for those spots, as they cannot transmit redstone power. However, the 4 central door blocks moved by the pistons can be glass.
- Hiding the Mechanism: You can build a simple doorframe and walls around the sticky pistons and torch towers to completely conceal the mechanics.
- Mob Proofing: Note that wooden pressure plates can be triggered by dropped items and all mobs. Use stone pressure plates on the outside of your base so only players and mobs can open it, or replace the exterior plates with a button if you want to prevent creepers and zombies from walking inside.




