Observer Chasing Lights Display

An observer chasing lights display creates a continuous wave of light across a row or frame of redstone lamps. This simple, slim circuit is ideal for highlighting signs, framing doorways, or adding a disco effect to your base without bulky wiring.

Displays & LightingBeginnerBedrock Edition
Observer Chasing Lights Display video tutorial

Video: Minecraft Bedrock. Chasing lights using Redstone Lamps. Disco lights or sign highlights. Tutorial. by Quinn Dexter

How to build it

  1. Place the Forward-Facing Observers

    Decide on the shape of your display, such as a straight line or a hollow square frame for a doorway. Place a layer of observers so that their output backs (the red dot) face forward toward the front of the display, and their faces point toward the back.

  2. Add the Redstone Lamps

    Attach redstone lamps directly onto the output side of every observer you just placed. This forms the visible front of your light show.

  3. Create the Chasing Observer Loop

    Behind the first layer of observers, place a second layer of observers arranged in a continuous loop around the back. Each observer in this back layer must watch the previous observer and point its output arrow into the next one along the path.

  4. Align the Corners

    If you are building a square or loop frame, carefully check the corners of your back observer chain. You may need to look straight up, down, or break and replace corner blocks to ensure the arrows follow a single continuous direction around the frame.

  5. Insert Redstone Dust to Start the Loop

    Pick one corner or end of your back observer chain, break a single observer, and place one piece of redstone dust in that gap. The dust bridges the loop and immediately triggers the chasing light cycle.

  6. Add an On/Off Switch

    Place a solid block next to the redstone dust and attach a lever to it. Flipping the lever on will continuously power the dust and stop the lights; flipping it off lets the chasing cycle run.

How it works

This circuit relies on a chain of observers passing a short redstone pulse around a loop:

  • The Back Loop: Each observer in the back layer detects a state change from the observer behind it and outputs a 1-tick pulse into the next observer in line.
  • The Redstone Dust Bridge: Replacing one observer in the loop with redstone dust links the end of the chain back to the beginning and provides an easy point to control the clock.
  • The Lamp Layer: The front layer of observers watches the back loop. As the pulse travels around the back chain, each front observer detects the change and briefly powers its attached redstone lamp in sequence, creating a moving wave of light.
  • The Kill Switch: Flipping the lever locks the redstone dust into a constantly powered state. Since observers only trigger when a signal changes state, keeping the dust permanently powered stops the loop from updating.

Tips & variations

  • Corner Alignment: When building a square frame around a doorway, placing observers facing straight up or down can be tricky. Stand directly beneath or above the placement spot to make sure the arrow points along the loop.
  • Slight Loop Delay: Using a piece of redstone dust at the corner introduces a tiny pause between the last lamp and the first lamp in the loop, but it keeps the wiring much slimmer than running a full redstone line from bottom to top.
  • Shapes: You can adapt this same two-layer observer principle to straight lines, squares, or circular frames of any size.

Frequently asked questions

Why are my lights stuck or not chasing all the way around?
One of the observers in the back loop is likely facing the wrong direction, especially at a corner. Check the arrows on every observer to make sure they follow one continuous path into the redstone dust.
How do I turn the chasing lights off?
Place a block with a lever next to the single piece of redstone dust in the back loop and turn the lever on. Keeping that dust permanently powered stops the observers from detecting changes.
Can I build this around a doorway or sign?
Yes, the loop design leaves the center completely hollow, making it great for framing doorways or highlighting signs.

Components used

More light show