
Video: TNT Duping Flying Machine for Minecraft 1.21 by The Master Miner
How to build it
- Tower Up Safely
Pillar up high above the ground where you want to excavate so the exploding TNT cannot bounce up and destroy the flying machine. Break the lower pillar blocks, leaving one floating block in the air.
- Set Up the TNT, Wall, and First Observer
Use temporary blocks to offset by one block, then place your TNT on top of the temporary support. Place the cobblestone wall directly on top of the TNT, and attach an observer next to the wall with its red output dot facing outward toward you. Break the temporary support blocks below the TNT.
- Build the Lower Slime Frame
Attach two slime blocks extending from the observer, then add an L-shape of two more slime blocks to the side so it wraps around the TNT and wall assembly. Place one more slime block directly on top of the outer corner of that L-shape.
- Install the First Sticky Piston
Go back to the observer side and place a sticky piston facing inward toward the raised slime block you just placed.
- Build the Upper Slime Frame and Second Piston
Attach a row of three slime blocks to the front of that sticky piston, and add one more slime block to the side to form a gap next to the first section. In that gap, place your second sticky piston facing the exact opposite direction of the first sticky piston.
- Attach the Coral Fan, Rail, and Minecart
Drop down to the lower slime assembly and attach your coral fan to the side of the slime block right next to the TNT. On top of the upper slime block assembly above the TNT module, place a detector rail and put a minecart directly on top of the rail.
- Place the Starting Observer
On the rear side of the machine, place two temporary blocks extending upward and break the bottom one. Place your second observer against the underside of the top temporary block so its arrow points straight down into the slime block below it.
- Launch and Stop the Machine
Break the remaining temporary block above the downward-facing observer to update it and launch the flying machine. To stop the machine at any time, simply break that downward-facing observer; repeat Step 7 and 8 whenever you want to start it again.
How it works
This contraption merges a classic two-way slime block flying machine with a movable TNT duplication module:
- Flying Engine: The two opposing
sticky pistonsandobserversform a self-sustaining push-pull loop. When you break the temporary block above the rear observer, it detects a block update and pulses its sticky piston, pushing the front half of the machine forward. - Alternating Movement: That forward movement updates the second observer, which fires the opposing sticky piston to pull the rear half of the machine along, repeating endlessly.
- TNT Duplication: The
detector railwith aminecarton top powers the adjacent block while in motion. Because theTNT,cobblestone wall, andcoral fanare pushed in a specific update order by the slime blocks, the game ignites and drops a primed TNT entity at the exact same tick the solid TNT block is moved forward, duplicating it on every step.
Tips & variations
- Java Edition Only: TNT duplication relies on piston update order and quasi-connectivity quirks exclusive to Minecraft Java Edition. This will not duplicate TNT on Bedrock Edition.
- Build High Enough: Always build the machine at least 15–20 blocks above the highest terrain in its path; otherwise, blast damage from the first few drops will blow up the slime blocks.
- Stopping Dock: If you don't want to chase the machine to break the observer manually, place an immovable block (like obsidian or a furnace) in its path where you want it to stop.
- Coral Fan Note: Any dead coral fan works, and even live coral fans will immediately die and work fine once placed out of water.




