
Video: Minecraft Bedrock - A Quick Double Pulse by Tufu
How to build it
- Place the Output Dispenser
Start by placing your dispenser facing the area where you want the liquid to appear, such as the bottom corner of a Nether portal frame. Put a single water bucket or lava bucket inside the dispenser.
- Build the Double Pulse Core
Behind or beside the dispenser, construct the back-and-forth pulse mechanism. Arrange your pulse components in a horizontal, vertical, or upside-down layout depending on the space available in your build.
- Attach the Lever Input
Place a lever on the input block of the circuit. Flipping this lever once will trigger the back-and-forth movement needed to generate two rapid pulses.
- Optional: Add a T Flip-Flop for Buttons
If you want to activate the circuit with a button instead of a lever, connect a dropper-based T flip-flop in front of the input. Place a single item inside the bottom dropper so each button press toggles the state and fires the double pulser.
How it works
This circuit operates by converting a single state change into a rapid back-and-forth action:
- First Pulse: When the
Leveris flipped (or the T flip-flop toggles), the circuit immediately sends an initial redstone pulse into theDispenser, placing the water or lava source block. - Second Pulse: As the mechanism finishes its quick back-and-forth cycle, it fires a second pulse just ticks later. This powers the
Dispensera second time, pulling the liquid back into the bucket before it has enough time to spread to adjacent blocks.
Tips & variations
- Orientation Variants: The exact same wiring concept can be built flat (horizontal), upright (vertical), or upside down to fit cleanly around walls, ceilings, or floors.
- Using Lava: While water will reliably retract without flowing at this speed, lava in Bedrock Edition has a tiny chance to spread immediately upon being dispensed. Keep flammable blocks away just in case.
- Button Conversion: Because the base circuit relies on a toggled state from a lever, wiring a button directly to it can throw off the timing. Always route a button through an item-based T flip-flop first.

