
Video: Redstone For Dummies - Episode 8 - IMPLIES Gates by J4V4N0
How to build it
- Set Up Input A (Single NOT Gate)
Place an opaque building block on the ground with a lever on it (or redstone dust leading into it) to act as Input A. Attach a redstone torch to the output side of this block to invert the signal.
- Set Up Input B (Double NOT Gate)
A couple of blocks away, place a block with a lever for Input B and attach a redstone torch to its side. Run a piece of redstone dust from that torch into a second building block, and place another redstone torch on the far side of that second block.
- Connect Both Branches to the Output
Place redstone dust so that both the single torch from Input A and the final torch from Input B power the exact same output redstone line.
- Test the Logic States
Flip the levers to test the gate. The output redstone dust should only turn completely off when Input A is switched ON and Input B is left OFF.
How it works
The IMPLIES gate works by combining an inverted input with a non-inverted (double-inverted) input into a single shared redstone line (acting as an OR connection):
- Input A (NOT Gate): The first branch uses a single redstone torch. When Input A is OFF, its torch stays ON and powers the output line. When Input A is turned ON, its torch turns OFF.
- Input B (Double NOT Gate / Repeater): The second branch runs through two consecutive redstone torches in a row. When Input B is OFF, the first torch is ON, which holds the second torch OFF. When Input B is turned ON, the first torch turns OFF, allowing the second torch to turn ON and power the output line.
- Shared Output: Because both final torches touch the same output dust, the output will remain ON as long as at least one of those torches is lit. The only way both torches turn off simultaneously is when Input A is ON (shutting off its single torch) and Input B is OFF (keeping its second torch off).
Tips & variations
- Compact vs. Isolated Variants: You can build a slightly smaller version where Input B feeds directly into the shared output line, or use the two-torch repeater method shown in the video to keep Input A and Input B more isolated from each other.
- Kill Switch Application: As mentioned in the tutorial, you can wire a combination lock or vault door through this gate so that flipping an interior "kill switch" forces the circuit into the OFF state, disabling the mechanism from the inside.
- Java & Bedrock Compatibility: Because this circuit only relies on basic redstone torch inversion and dust, it works identically in all versions of Minecraft.





