
Video: How To Minecraft 101 Working Redstone Lamps and Switches by Ritzie Ritz
How to build it
- Install the Redstone Lamps in the Ceiling
Break out a spot in the ceiling of your room where you want the overhead fixtures to sit and place your Redstone Lamps.
- Place the Light Switch Lever
Attach a Lever to an interior wall near the entrance. Leave at least one block of space between the door and the lever so flipping the switch does not accidentally open and close your door.
- Build a Block Staircase Behind the Wall
Go to the outside of the wall right behind the block holding your lever. Place solid building blocks in a step-up staircase formation leading from the back of the lever block up to the top of your ceiling.
- Connect the Redstone Dust
Lay a trail of Redstone Dust directly away from the back of the lever block, up the staircase of blocks, and onto the roof until the dust rests directly on top of the Redstone Lamps.
- Test the Light Switch
Go back inside your room and flick the lever to make sure the signal travels all the way to the roof and lights up the Redstone Lamps.
- Conceal the Exterior Wiring
Build an outer wall and a raised roof two blocks high over the Redstone trail to hide the wiring. Always leave a one-block air gap above stepping Redstone dust so solid blocks do not cut off the wire connection.
How it works
This circuit relies on basic direct Redstone power transmission from an input switch to an output block:
- Strong Power Input: When you flip the
Leverto the ON position, it strongly powers the solid wall block it is attached to. - Signal Transmission:
Redstone Dustplaced directly behind and pointing into that wall block picks up a signal strength of 15 and carries the power up the staircase of building blocks toward the roof. - Lamp Activation: Running the
Redstone Dustdirectly on top of theRedstone Lampspowers the lamps and illuminates the room until the lever is switched off again.
Tips & variations
- Avoid Cutting Redstone Wire: When covering up your wiring, never place a solid block directly diagonally above a lower piece of Redstone dust on a staircase. Doing so will visually and functionally sever the Redstone line going up the steps. Leave a 2-block-tall clearance when framing your false roof and walls.
- Wire Alignment at the Lever: Make sure your Redstone dust leads straight out of the block the lever is attached to rather than running strictly parallel past it; dust that runs alongside the block without pointing into it will not draw power.
- Survival Mode Mob Spawning: Be careful when turning off the lights in Survival mode! If your room has no windows or secondary light sources, hostile mobs can spawn inside while the lamps are switched off.





