Redstone Lamp Light Switch

A Redstone Lamp light switch lets you toggle your house's interior ceiling lights on and off with the flick of a single lever. It replaces standard torches and glowstone with controllable lighting, making it a great beginner redstone project for any survival home or creative build.

Displays & LightingBeginnerJava Edition
Redstone Lamp Light Switch video tutorial

Video: How to Make a Redstone Lamp Light Switch in Minecraft 1.7.4 by SenpaiJesus

How to build it

  1. Install the Ceiling Lamps

    Break holes in the ceiling of your room where you want your lights to be and place your Redstone Lamps flush with the ceiling.

  2. Place the Wall Lever

    Inside the room, place a Lever on a convenient wall block to act as your light switch.

  3. Build a Staircase Behind the Wall

    Go behind or outside the wall where the lever is attached. Place solid building blocks stepping upward from the block behind the lever up to the top of your roof.

  4. Wire the Lever to the Roof

    Place Redstone Dust directly behind the block holding the lever, then trail the dust up your stepped blocks until it reaches the top of the ceiling.

  5. Connect the Redstone Lamps

    Run the trail of Redstone Dust directly across the top of the Redstone Lamps in your ceiling. If you have multiple rows or spread-out lamps, branch the dust line out so it runs over every lamp.

  6. Test and Conceal the Wiring

    Head back inside and flip the lever to make sure all the lamps light up. Once everything works, build an outer roof over the top to hide the exposed redstone wiring.

How it works

This circuit works using basic direct redstone power and signal strength:

  • Input: Flipping the Lever powers the solid wall block it is attached to at a full signal strength of 15.
  • Transmission: The Redstone Dust placed directly behind that wall block picks up the power and carries it up the stepped blocks onto the roof.
  • Output: When the Redstone Dust runs directly on top of a Redstone Lamp, it powers the lamp and causes it to emit light. Furthermore, a directly powered lamp will also activate any immediately adjacent Redstone Lamps, allowing you to light up clusters easily.

Tips & variations

  • Watch Out for Doors: Avoid placing the lever or routing the redstone dust right next to your front doors. If the signal reaches a door, flipping your light switch will also open and close the door.
  • Signal Strength Limit: Redstone dust only carries power for 15 blocks. If you have a large roof with many lamps far away from the switch, the signal will eventually run out unless you extend it with a Redstone Repeater.
  • Mob Proofing the Roof: While building a hollow attic space to hide the wiring, remember that dark spaces on top of your roof can spawn monsters like Creepers. Light up the hidden roof space with a few blocks of Glowstone or torches where they cannot be seen from below.

Frequently asked questions

Why aren't my furthest Redstone Lamps turning on?
A lever's redstone signal only travels 15 blocks through redstone dust. If your wiring is longer than 15 blocks, the dust at the end won't have enough power to light the lamps.
Why does my door open when I flip the light switch?
If your lever or the redstone dust behind the wall is within one block of a door, it will power the door at the same time. Move your switch at least two blocks away from any doors.
How do I get the redstone signal from the wall up to the ceiling?
Redstone dust can climb one block at a time. Place solid blocks in a staircase pattern going up the outside or inside of your wall, and lay the redstone dust up the steps.

Components used

More lamp switch / light control