
Video: Minecraft - How To Make A Doorbell by Biggs87x
How to build it
- Dig the Main Pit
Find the spot for your front entrance and dig a 2x3 hole that is 2 blocks deep.
- Place the Note Blocks
Place four note blocks inside the pit so you have a front pair and a back pair with a one-block gap in the middle.
- Add the Center Repeater
Place one redstone repeater between the front two note blocks facing toward the back pair. Right-click the repeater three times to set it to its maximum 4-tick delay.
- Tune the Back Note Blocks
Right-click both of the back note blocks once each so they are set to the same pitch.
- Tune the Front Note Blocks
Go to the front pair of note blocks. Right-click the front-left note block 17 times, and right-click the front-right note block 13 times.
- Build the Door Frame and Button
Construct your door frame above the edge of the pit and place your door. Attach a button to the wall block next to the door at head or chest height.
- Dig the Wiring Trench
On the side of the door frame where the button is located, dig another 2x3 area that is 2 blocks deep to connect the wall to your underground note blocks.
- Build the Redstone Staircase
Place solid building blocks behind the button block stepping down into the trench. Place two pieces of redstone dust on the top blocks directly taking the signal from behind the button, followed by a second redstone repeater leading down into the pit.
- Connect the Dust to the Note Blocks
Run a trail of redstone dust from the output of the second repeater all the way around to the front pair of note blocks.
- Test and Cover the Circuit
Press the button to make sure both chords chime in sequence. Once working, cover up the trenches and exposed wiring with walls, logs, and flooring.
How it works
When you press the button on the door frame, it sends a redstone pulse through the wall block into the redstone dust behind it. The signal travels down the stepped blocks and through the first redstone repeater, which keeps the signal strong enough to reach the bottom pit.
- First Chime (Ding): The redstone dust powers the front two note blocks (tuned to 17 and 13 clicks) simultaneously, playing a two-note harmony.
- Second Chime (Dong): At the same time, the signal enters the center redstone repeater set to 3 clicks (4 redstone ticks of delay). After a brief pause, it triggers the back two note blocks (tuned to 1 click each) to play the lower finishing tone.
Tips & variations
- Keep Air Above Note Blocks: Note blocks require at least one block of empty air directly above them to play a sound. When covering up your floor and walls, make sure you do not place solid blocks directly on top of the four note blocks.
- Instrument Sounds: The block directly underneath a note block determines which instrument it plays. Dirt or grass gives a standard harp/piano chime, while stone creates a bass drum sound and wood creates a bass guitar sound. For a classic doorbell chime, keep dirt, grass, or air beneath them, or place gold blocks underneath for an actual bell sound in newer versions.
- Customizing the Pitch: If you want a slower or faster gap between the two chimes, adjust the delay on the repeater sitting between the note blocks.

