
Video: Redstone Basics - OR/NOR Gates | NoobStone | Minecraft Bedrock Edition 1.19 Redstone Tutorial by NoobCraft
How to build it
- Place the Input Triggers
Set down two levers (or any other redstone power sources) with a small gap between them to act as Input A and Input B.
- Connect the Inputs with Redstone Dust
Place redstone dust coming directly out of each lever, then lay a line of dust between them so the two separate trails merge together.
- Run the Output Line (OR Gate Complete)
Extend a line of redstone dust from the merged junction straight into your output device, such as a redstone lamp. You now have a working OR gate that activates whenever either lever is flipped.
- Add a Solid Block to Convert to a NOR Gate
To turn your OR gate into a NOR gate, break the dust at the junction where the two input lines meet your output line and place a solid building block in that spot.
- Attach the Inverting Redstone Torch
Make sure the redstone dust from both inputs runs directly into the solid block, then place a redstone torch on the front side of that block facing your output line. The output will now stay on by default and turn off whenever any lever is activated.
How it works
Both circuits rely on how redstone dust merges power from multiple sources:
- OR Gate Logic: Because both input lines connect to the same stretch of
Redstone Dust, powering Input A, Input B, or both will send a signal down the shared output wire. The output only turns off when both inputs are completely off. - NOR Gate Logic: A NOR gate is simply an OR gate connected to a NOT gate (inverter). By running the merged input dust into a solid block with a
Redstone Torchattached to it, the signal is inverted. When all inputs are off, the torch stays lit and powers the output. When any input turns on, it powers the solid block, which turns off the redstone torch and deactivates the output.
Tips & variations
- Adding More Inputs: You are not limited to two triggers. You can tie three or more input lines into the same redstone dust junction as long as the signal strength (up to 15 blocks) is strong enough to reach the output or theNOR gate's torch block.
- Practical Base Example: A great survival use for an OR gate is wiring an indoor lever and an outdoor
Daylight Detector(set to inverted/night mode) to the sameRedstone Lamp. The light will turn on automatically at night, while still letting you flip the indoor lever to turn it on manually during the day. - Preventing Backfeed: If you are connecting complex circuits to the inputs rather than simple levers, place a repeater on each input line before they merge so power from Input A cannot travel backward into Input B's circuit.

