
Video: Minecraft Redstone Tutorial 5 - The OR Gate by Lodorenos
How to build it
- Place the Core Block
Place a single solid opaque block on the ground or inside the wall where you want your inputs to meet.
- Attach the Input Levers
Place one lever on one side of the block and a second lever on the opposite side of the same block.
- Connect the Output
Run redstone dust from one of the remaining sides of the block, or place an output component like a door right next to the block.
- Test Both Inputs
Flip either lever ON to verify that the output activates, and confirm it stays ON even if both levers are switched ON at the same time.
How it works
This circuit works through direct strong-powering of a single solid block:
- Input A or Input B OFF: When both levers are off, the central block is unpowered and the output stays off.
- Either Lever ON: Flipping either lever strongly powers the solid block it is attached to.
- Output Activation: Because the solid block is strongly powered, it emits a redstone signal to any adjacent redstone dust or mechanism (like a door) on its other sides, fulfilling the OR logic condition (ON if A
ORB is ON).
Tips & variations
- Limitation with Levers: Because this is an OR gate, if one lever is left in the ON position, flipping the other lever on the opposite side of the wall will not close the door. For independent toggling from both sides, upgrade to an XOR gate or use buttons instead of levers.
- Signal Isolation: If your two inputs are coming from distant redstone dust lines rather than levers on the same block, place a redstone repeater feeding into the block from each line so the signals do not backfeed into each other.
- Block Choice: Make sure the central block is a solid opaque block (like stone or planks); transparent blocks like glass cannot be powered this way.
